NAME
wb —
Winbond W89C840F 10/100 Ethernet
device
SYNOPSIS
wb* at pci?
amphy* at mii?
DESCRIPTION
The wb driver provides support for PCI
Ethernet adapters and embedded controllers based on the Winbond W89C840F
Fast Ethernet controller chip. This includes the TRENDnet TE100-PCIE and
various other cheap boards. The 840F should not be confused with the 940F,
which is an NE2000 clone and only supports 10Mbps speeds.
The Winbond controller uses bus master DMA and is designed to be a DEC "tulip" work-alike. It differs from the standard DEC design in several ways: the control and status registers are spaced 4 bytes apart instead of 8, and the receive filter is programmed through registers rather than by downloading a special setup frame via the transmit DMA engine. Using an external PHY, the Winbond chip supports both 10 and 100Mbps speeds in either full or half duplex.
The wb driver supports the following media
types:
- autoselect
- Enable autoselection of the media type and options. This is only supported if the PHY chip attached to the Winbond controller supports NWAY autonegotiation. The user can manually override the autoselected mode by adding media options to the appropriate hostname.if(5) file.
- 10baseT
- Set 10Mbps operation. The mediaopt option can also be used to select either full-duplex or half-duplex modes.
- 100baseTX
- Set 100Mbps (Fast Ethernet) operation. The mediaopt option can also be used to select either full-duplex or half-duplex modes.
The wb driver supports the following media
options:
- full-duplex
- Force full duplex operation.
- half-duplex
- Force half duplex operation.
Note that the 100baseTX media type is only available if supported by the adapter. For more information on configuring this device, see ifconfig(8).
DIAGNOSTICS
- wb0: couldn't map memory
- A fatal initialization error has occurred.
- wb0: couldn't map interrupt
- A fatal initialization error has occurred.
- wb0: watchdog timeout
- The device has stopped responding to the network, or there is a problem with the network connection (cable).
- wb0: no memory for rx list
- The driver failed to allocate an mbuf for the receiver ring.
- wb0: no memory for tx list
- The driver failed to allocate an mbuf for the transmitter ring when allocating a pad buffer or collapsing an mbuf chain into a cluster.
SEE ALSO
amphy(4), arp(4), ifmedia(4), intro(4), netintro(4), pci(4), hostname.if(5), ifconfig(8)
HISTORY
The wb device driver first appeared in
FreeBSD 3.0. OpenBSD support
first appeared in OpenBSD 2.5.
AUTHORS
The wb driver was written by
Bill Paul
<[email protected]>.
BUGS
The Winbond chip seems to behave strangely in some cases when the
link partner switches modes. If, for example, both sides are set to 10Mbps
half-duplex, and the other end is changed to 100Mbps full-duplex, the
Winbond's receiver suddenly starts writing trash all over the RX
descriptors. The wb driver handles this by forcing a
reset of both the controller chip and attached PHY. This is drastic, but it
appears to be the only way to recover properly from this condition.